DivaEVB-Lite
Revision as of 12:56, 20 June 2013 by DevWikiAdmin (talk | contribs)
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
Info Box
|
|
The information here provided are preliminary and subject to change. |
|
Contents
Introduction[edit | edit source]
DivaEVB-Lite is a carrier board designed to host Diva system-on-module. It can also act as an adaptation board used in combination with Dacu carrier board. Therefore two different versions exist that are a little bit different.
DivaEVB Standalone version[edit | edit source]
The following picture shows Diva-EVB-Lite's block diagram when configured as standalone carrier board:
DivaEVB for Dacu[edit | edit source]
 When used in combination with Dacu, please note the points listed below: |
- the following parts are not installed because their respective functionality is already implemented on DACU board
- USBOTG port
- RS232 UART port
- PSU.
- some wired connections are necessary; these are detailed in the Schematics section.
- on J18 connector, a jumper must be placed on positions 1-2 and 3-4
Please see also Dacu for the Diva SOM.
Schematics[edit | edit source]
|
Please note that Orcad CIS is required to get all the information about BOM variants included in .dsn files. PDF files show the view of the default BOM variant used to manufacture the board. Components that are not populated are denoted as "Do Not Stuff". |
- ORCAD: http://www.dave.eu/system/files/area-riservata/divaevb-lite-1.0.2-DIVELK-dsn.zip
- PDF: http://www.dave.eu/system/files/area-riservata/divaevb-lite_S.DIVELK.L.S.1.0.2.pdf
