BORA Xpress SOM/BORA Xpress Hardware/Power and Reset/PL initialization signals
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
| History | |||
|---|---|---|---|
| Issue Date | Notes | ||
| 2021/11/22 | New documentation layout | ||
PL initialization signals[edit | edit source]
This page provides information about the Programmable Logic (PL) initialization signals: PROGRAM_B, INIT_B, and DONE.
Please refer to Zynq Technical Reference Manual UG-585 for more information about usage and configuration of initialization circuit and signals.
As described in Table 6-24: PL Initialization Signals of Zynq-7000 SoC Technical Reference Manual (UG585), the user can initialize the PL using these signals.
BORA, BORAX, and BORALite SOM are configured in the following way:
- PROGRAM_B has an internal 10kΩ pull-up to VCCO_0 as indicated on Xilinx AR#56272
- INIT_B has no pull-up/down
- DONE has no pull-up/down. It does not require any external pull-up or pull-down but can be used for connecting a user led for a configuration completed indication (see for example BoraXEVB schematics).
External pull-ups[edit | edit source]
- PROGRAM_B: UG-585 indicates to use a 4.7kΩ pull-up resistor for this signal. This value was not known when the Xilinx Zynq 7000 family was released. Nevertheless, to date, no issues have been reported although this pull-up is a little bit weaker. In any case, an external pull-up to a 3.3V controlled power domain can be put in parallel with the internal 10kΩ resistor to get a stronger pull-up. For more details, please contact the technical support.
- INIT_B: for using this signal as PL initializing signal Low-to-High transition, place an external pull-up to a 3.3V controlled power domain.
