Open main menu

DAVE Developer's Wiki β

Wireless Module (DWM)

Revision as of 13:15, 5 November 2012 by DevWikiAdmin (talk | contribs) (Pinout and detailed pin functions)

Info Box
Dwm 01.png Applies to DWM


WorkInProgress.gif

Contents

IntroductionEdit

 


SpecificationEdit

Power consumptionEdit

Pinout and detailed pin functionsEdit

DWM can be connected to the host board through the J1 connector. The following table reports the connector pinout:

Pin number Name Type Description Voltage Note
1 BT_EN Input Bluetooth Enable 3.3V
2 WIFI_EN Input WLAN Enable 3.3V
3 UART2_RTSn Output Bluetooth HCI UART RTS 3.3V
4 WIFI_IRQ Output WLAN Interrupt Request 3.3V
5 UART2_TXD Input/Output Bluetooth HCI UART TX 3.3V
6 BT_F2 Output Bluetooth Wakeup / DC2DC Mode 3.3V
7 UART2_CTSn Input Bluetooth HCI UART CTS 3.3V
8 WIFI_CLK_REQ(A) Output HOST_WakeUp 3.3V
9 UART2_RXD Input Bluetooth HCI UART RX 3.3V
10 NC Reserved for future use - Please leave unconnected.
11 DGND Ground -
12 NC Reserved for future use - Please leave unconnected.
13 DAT3 SDIO Data Bit 3 3.3V
14 NC Reserved for future use - Please leave unconnected.
15 DAT2 SDIO Data Bit 2 3.3V
16 NC Reserved for future use - Please leave unconnected.
17 DAT1 SDIO Data Bit 1 3.3V
18 NC Reserved for future use - Please leave unconnected.
19 DAT0 SDIO Data Bit 0 3.3V
20 NC Reserved for future use - Please leave unconnected.
21 DGND Ground -
22 DGND Ground -
23 SDO_CMD Input/Output SDIO Command Line 3.3V
24 SDO_CLK Input SDIO Clock 3.3V
25 DGND Ground -
26 DGND Ground -
27 3.3V Power -
28 3.3V Power -
29 5V Power -
30 5V Power -

Pinout referenceEdit

The following picture shows the reference pins of the J1 connector:


 

ResetEdit

Integration guideEdit

This section provides useful information and resources that allow the system designer to integrate DWM module in his/her application very quickly.

Typical scenariosEdit

Mechanical informationEdit

The following image shows the module dimensions:

 
DWM dimensions

LayoutEdit

The following images show the module layout:

 
DWM Top View
 
DWM Bottom View

The component view (top and bottom) is avalable as PDF file:

3DEdit

Qualification testsEdit