Difference between revisions of "Wireless Module (DWM)"
DevWikiAdmin (talk | contribs) (→Layout) |
DevWikiAdmin (talk | contribs) (→Mechanical information) |
||
| Line 98: | Line 98: | ||
===Mechanical information=== | ===Mechanical information=== | ||
| + | |||
| + | The following image shows the module dimensions: | ||
| + | |||
| + | [[File:Dwm-layout-top.png|thumbnail|center|200px|DWM Layout Top]] | ||
| + | |||
* DXF: http://www.dave.eu/download/restricted/add-on-modules/dwm/CS061412.dxf | * DXF: http://www.dave.eu/download/restricted/add-on-modules/dwm/CS061412.dxf | ||
Revision as of 16:57, 2 November 2012
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
Info Box
|
Contents
Introduction[edit | edit source]
Specification[edit | edit source]
Power consumption[edit | edit source]
Pinout and detailed pin functions[edit | edit source]
DWM can be connected to the host board through the J1 connector. The following table reports the connector pinout:
| Pin number | Name | Type | Description | Voltage | Note |
| 1 | BT_EN | ||||
| 2 | WIFI_EN | ||||
| 3 | UART2_RTSn | ||||
| 4 | WIFI_IRQ | ||||
| 5 | UART2_TXD | ||||
| 6 | BT_F2 | ||||
| 7 | UART2_CTSn | - | |||
| 8 | WIFI_CLK_REQ(A) | - | |||
| 9 | UART2_RXD | - | |||
| 10 | NC | Reserved for future use | - | Please leave unconnected. | |
| 11 | DGND | Ground | |||
| 12 | NC | Reserved for future use | - | Please leave unconnected. | |
| 13 | DAT3 | - | |||
| 14 | NC | Reserved for future use | - | Please leave unconnected. | |
| 15 | DAT2 | - | |||
| 16 | NC | Reserved for future use | - | Please leave unconnected. | |
| 17 | DAT1 | - | |||
| 18 | NC | Reserved for future use | - | Please leave unconnected. | |
| 19 | DAT0 | ||||
| 20 | NC | Reserved for future use | - | Please leave unconnected. | |
| 21 | DGND | Ground | |||
| 22 | DGND | Ground | |||
| 23 | SDO_CMD | ||||
| 24 | SDO_CLK | - | |||
| 25 | DGND | Ground | |||
| 26 | DGND | Ground | |||
| 27 | 3.3V | Power | |||
| 28 | 3.3V | Power | - | ||
| 29 | 5V | Power | - | ||
| 30 | 5V | Power | - | ||
Reset[edit | edit source]
Integration guide[edit | edit source]
This section provides useful information and resources that allow the system designer to integrate DWM module in his/her application very quickly.
Typical scenarios[edit | edit source]
Mechanical information[edit | edit source]
The following image shows the module dimensions:
Layout[edit | edit source]
The following images show the module layout:
The component view (top and bottom) is avalable as PDF file:
