BORA Xpress SOM/BORA Xpress Hardware/Peripherals/USB
< BORA Xpress SOM | BORA Xpress Hardware
Revision as of 10:48, 22 November 2021 by U0007 (talk | contribs) (Created page with "{{#lst:Processing_system_peripherals_(BORAXpress)|USB}}")
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
Bora provides one USB 2.0 (Full Speed, up to 480 Mbps) port with on-board PHY (SMSC USB3317) and support to the On-The-Go (OTG) specifications. The transceiver is connected to the USB1 controller (MIO bank 1, pins PS_MIO[28:39]). The following table describes the interface signals:
| Pin name | Conn. pin | Function | Notes |
|---|---|---|---|
| USBP1 | J1.114 | D+ pin of the USB cable | - |
| USBM1 | J1.116 | D- pin of the USB cable | - |
| USBOTG_CPEN | J1.111 | External 5 volt supply enable | This pin is used to enable the external Vbus power supply |
| OTG_VBUS | J1.113 | VBUS pin of the USB cable | - |
| OTG_ID | J1.115 | ID pin of the USB cable | For non-OTG applications this pin can be floated. For an A-device ID is grounded. For a B-device ID is floated. |
