{{ImportantMessage|text='''Customers are strongly recommended to register their kits'''. Registration grants access to reserved material such as source code and additional documentation.}}
Please register your development kit by sending an email to [mailto:support-lynxbora@dave.eu support-lynxbora@dave.eu], providing the kit P/N and CODE.
===Target setup and first boot===
This section describes how to quick quickly start SBC Lynx board delivered along with BoraX/BoraXEVB system included in the BXELK kit:*on target side, connect a TTL/USB serial null-modem cable to J42 on J17 DB9 connector; J42 pinout is:** 1: TX data** 2: RX data** 3: 3.3V** 4: GND, denoted also as UART1*on host side , connect the other end of the null-modem cable to a COM port and start your favorite terminal software that will be used to interact with the target's serial console; communication parameters are 115200-8-N-1*optionally connect the system BoraXEVB board to an Ethernet LAN by plugging cable into connector J16J8, also denoted as BORAX ETHERNET*connect 12V power supply to J35 JP2 connector; J35 pinout is:**1: GND**2: VIN, also denoted as PSU 12V JACK*insert the microSD card in the slot J43J21, also denoted as MICROSD.
[[File:SBCLynx-BXELKTBD.png|thumb|center|600px|Target setup for first boot]]
Once power has been applied to the target, FSBL and U-Boot bootloader bootloaders will be fetched from the SPI NOR flash that equips BoraX SOM and executed. Boot messages will be printed out to the serial console. Redundant U-Boot environment is stored in the NOR flash as well, as depicted in the following image.