Bureaucrats, dave_user, Administrators
8,186
edits
Changes
no edit summary
The pinout of the J1, J2 and J3 connectors of the Bora EVB is the same of the [[Pinout (Bora)|counterpart connectors on BORA module]].
<section begin=Power Supply/>
=== Power supply - J7 ===
|-
|}
<section end=Power Supply/>
<section begin=Reset button/>
=== Reset button - S6 ===
|}
<section end=Boot Configurations/>
<section begin=Watchdog/>
=== WatchDog Settings - S1, S2 and S3 ===
S1, S2 and S3 are dip-switch to override the default startup delay and timeout of the Bora module watchdog.
| WD_SET2 = '0' || OFF || ON
|}
<section end=Watchdog/><section begin=Ethernet0/>
=== Ethernet port #0 (ETH0) - J8 ===
|-
|}
<section end=Ethernet0/><section begin=Ethernet1/>
=== Ethernet port #1 (ETH1) - J9 ===
|-
|}
<section end=Ethernet1/>
=== POWER GOOD signals selector - J10 ===
J10 is a 8-pin 4x2x2.54 pitch vertical header used for the selection - through jumpers - of the POWER GOOD options. The following table reports the pinout of the connector:
