3,260
edits
Changes
m
|Switch position!DIP SWITCH|BTMODE!OFF Position!ON Position
|S5.6 on|RFU|-|S5.7 off|default|-|S5.7 on|BTMODE3=1|-|S5.8 off|default|-|S5.8 on|RFU|-|S5.9 off|default|-|S5.9 on|BTMODE4=1|-|S5.10 off|default|-|S5.10 on|RFU|-|S5.11 off|default|-|S5.11 on|RFU|-|S5.12 off|default|-|S5.12 on|RFU
table layout reviewd
This configuration can be changed by acting on S5 dip switch on bottom side of the board. Swithes allow to configure each BTMODE signal independently as summarized by following table. Settings denoted as RFU - that stands for "Reserved for future use" - '''must not be selected'''.
{| class="wikitable" !NELK versionNaonEVB-Lite Boot Settings
|-
|-
|S5.1 off|default|BTMODE0=1
|-
|S5.1 on2|BTMODE0=1default |RFU
|-
|S5.2 off3|default|RFU
|-
|S5.2 on4|RFUdefault |BTMODE1=0
|-
|S5.3 off5|default|BTMODE2=1
|-
|S5.3 on6|default |RFU
|-
|S5.4 off7|default|BTMODE3=1
|-
|S5.4 on8|BTMODE1=0default |RFU
|-
|S5.5 off9|default|BTMODE4=1
|-
|S5.5 on10|BTMODE2=1default |RFU
|-
|S5.6 off11|default|RFU
|-
|}