RIALTO SBC/Getting started/Connections and first boot

From DAVE Developer's Wiki
Jump to: navigation, search
History
Issue Date Notes
2023/01/10 First documentation release



Connections[edit | edit source]

This section describes how to quickly start the RIALTO SBC:

RIALTO SBC-first-connections.png

The system is programmed to automatically boot Linux at power up, loading the bootloader, the kernel and device tree image and the root file system from the SD card memory.

To connect to the system:

  • wire a 12Vcc power supply to J58 connector's terminals
  • connect the USB to TTL UART adapter to the J42 connector on the SBC and connect the USB side connector to a USB port on your computer
    • start your favorite terminal emulator software on PC (eg: PuTTY, Minicom, ...); communication parameters are 115200,N,8,1
  • (optional) connect the ethernet cable from your LAN hub/switch to the J16 RJ45 connector
    • start SSH, using the following parameters:
      • ip address: 192.168.0.89
      • username: root
      • empty password

Warning: please, pay attention to the debug cable header connection, see the picture here below:

RIALTO SBC-usb-to-serial.png

First boot[edit | edit source]

Once power has been applied, U-Boot bootloader will be executed and the debug messages will be printed on the serial console. U-Boot automatically runs the autoboot macro, that loads the kernel/dtb and launches it with the options for mounting the root file system from the SD card.

At the end of the boot process, a demo application is launched and you can interact with the system using the touchscreen. The Linux shell is available on the serial console. Moreover, both telnet and ssh services are available to connect to the system through the network.

Serial console[edit | edit source]

A simple Windows serial and SSH/telnet client and terminal can be downloaded from here.

The following picture shows the serial setup for connecting to the EVK:


PuTTY connection using Serial Port


once selected the COM[x] serial port, click the Open button which starts the terminal. Once powered, the EVK shows the U-boot debug messages printed on the serial console.

Connecting through SSH[edit | edit source]

The following picture shows the SSH connection to the EVK:


PuTTY connection using SSH


once selected the IP address, click the Open button which starts the terminal. Once connected, the EVK shows the linux kernel prompt login for inserting the login:


PuTTY SSH login


Then use the root login username without password:


PuTTY SSH connected