| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
| History | |||
|---|---|---|---|
| Issue Date | Notes | ||
| 2024/01/12 | First documentation release | ||
Contents
Wifi/Bluetooth interfaceEdit
DWM and DWS are DAVE WiFi addons that provide WiFi 802.11 bgn and Bluetooth connectivity.
DescriptionEdit
The Wifi/Bluetooth interfaces are available on RIALTO SBC at the connector J46.
J46 is a 30-pins 0.50mm Pitch SlimStack™ Receptacle. This connector is dedicated to the DWM/DWS optional add-on module.
SignalsEdit
The following table describes the interface signals:
| Pin# | Pin name | Pin function | Pin Notes |
|---|---|---|---|
| 1, 2 | 5V | Power supply | |
| 3, 4 | 3.3V | Power supply | |
| 5, 6, 9, 10, 19 | DGND | Ground | |
| 7 | TIWI_MMC2_CMD | ||
| 8 | TIWI_MMC2_CLK | ||
| 11 | TIWI_MMC2_DAT0 | ||
| 13 | TIWI_MMC2_DAT1 | ||
| 15 | TIWI_MMC2_DAT2 | ||
| 17 | TIWI_MMC2_DAT3 | ||
| 21 | UART2_RX | Used only for BT peripheral | |
| 23 | UART2_CTS | Used only for BT peripheral | |
| 24 | TIWI_BT_F5 | Used only for BT peripheral | |
| 25 | UART2_TX | Used only for BT peripheral | |
| 26 | TIWI_BT_F2 | Used only for BT peripheral | |
| 27 | UART2_RTS | Used only for BT peripheral | |
| 28 | TIWI_IRQ | ||
| 29 | TIWI_BT_EN | Used only for BT peripheral | |
| 30 | TIWI_EN | ||
| 12, 14, 16, 18, 20, 22 | N.C. | Not connected |
WiFiEdit
Device mappingEdit
The WiFi peripheral is mapped to the corresponding wlan<0> device in Linux. The network peripheral is visible under the ifconfig network configuration utility.
Device usageEdit
The peripheral uses the standard kernel interface and network protocol stack.
BluetoothEdit
Device mappingEdit
The BT peripheral is mapped to the /dev/ttymxc1 serial port in Linux. It can be mounted as an hci device with the hci tools commands.
Device usageEdit
The peripheral is used by the standard kernel interface and BlueZ protocol stack.