| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
IntroductionEdit
Quick startEdit
- connect the serial cable, provided with the board, to J25
- connect this cable to PC COM port through a NULL-modem cable (not provided)
- start your favourite terminal software on PC; communication parameters are:
- baud rate: 115200 Bps
- data bits: 8
- stop bits: 1
- parity: none
- (optional) to connect the system to Ethernet LAN, please plug cable on connector J3
- connect a 12Vcc power supply to JP1
Once power has been applied, U-Boot bootloader will be executed and the following messages will be printed on serial console (please note that messages may vary due different U-Boot releases)
CCCCCCCC U-Boot 2010.06-dirty (Apr 27 2012 - 18:58:24) [nelk-0.9.0-min] TI8148-GP rev 2.1 ARM clk: 600MHz DDR clk: 333MHz DRAM: 512 MiB Using default environment Hit any key to stop autoboot: 0 8192 KiB AT45DB642D at 0:0 is now current device ## Starting application at 0x81000000 ... U-Boot 2010.06-dirty (Apr 30 2012 - 19:23:20) [nelk-0.9.0] TI8148-GP rev 2.1 ARM clk: 600MHz DDR clk: 333MHz I2C: ready DRAM: 512 MiB NAND: HW ECC Hamming Code selected 1024 MiB MMC: OMAP SD/MMC: 0 Net: Detected MACID:d4:94:a1:8e:22:19 cpsw NAON#