Difference between revisions of "FAQs (Naon)"

From DAVE Developer's Wiki
Jump to: navigation, search
m
m (I've received the NELK package. How am I supposed to start working with it?)
Line 30: Line 30:
  
 
== I've received the NELK package. How am I supposed to start working with it? ==
 
== I've received the NELK package. How am I supposed to start working with it? ==
 +
 +
You can follow the steps listed below:
 +
 +
* Check che kit contents
 +
* If you have the bootable SD card:
 +
** insert the SD into the card reader on the carrier board
 +
** connect the power supply adapter to the main power supply and to the carrier board
 +
** connect the serial cable from your pc to the carrier board
 +
** start your terminal emulator program
 +
** switch on the power supply
 +
** monitor the boot process on the serial console
 +
* Install the DVDK virtual machine image
 +
* Build the software components for the Naon platform
 +
* Try to boot from network

Revision as of 10:35, 24 May 2013

WorkInProgress.gif

Info Box
Naon am387x-dm814x.png Applies to Naon

Introduction[edit | edit source]

This page collects all the Frequently Asked Question regarding Naon

General[edit | edit source]

Q: Where can I found Naon SOM hardware information?[edit | edit source]

A: please refer to the following pages:

Q: Do you provide an evaluation kit?[edit | edit source]

A: yes, we provide the Naon Embedded Linux Kit. Please refer to Naon_Embedded_Linux_Kit_(NELK)

Carrier board design[edit | edit source]

Q: Can you suggest some guidelines for the carrier board design?[edit | edit source]

A: As a starting point, you can refer to the Carrier_board_design_guidelines_(SOM) page, that will highlight some best practices.

Using NELK[edit | edit source]

I've received the NELK package. How am I supposed to start working with it?[edit | edit source]

You can follow the steps listed below:

  • Check che kit contents
  • If you have the bootable SD card:
    • insert the SD into the card reader on the carrier board
    • connect the power supply adapter to the main power supply and to the carrier board
    • connect the serial cable from your pc to the carrier board
    • start your terminal emulator program
    • switch on the power supply
    • monitor the boot process on the serial console
  • Install the DVDK virtual machine image
  • Build the software components for the Naon platform
  • Try to boot from network