| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
| History | |||
|---|---|---|---|
| Issue Date | Notes | ||
| 2020/12/31 | First Release | ||
Contents
Peripheral EthernetEdit
The Ethernet peripheral enables the devices to transmit and receive data over Ethernet in compliance with the IEEE 802.3-2002 standard.
DescriptionEdit
The 10/100/1000-Mbit/s Ethernet interface available on ETRA SOM is based on STM32MP1 SoC.
On ETRA SOM the SoC is directly interfaced with an onboard ETH PHY chip (MICROCHIP KSZ8091RNAIA) with the following features:
- Auto-Negotiation to Automatically Select the Highest Link-Up Speed (10/100 Mbps) and Duplex (Half/Full)
- On-Chip Termination Resistors for the Differential Pairs
- HP Auto MDI/MDI-X to Reliably Detect and Correct Straight-Through and Crossover Cable Connections
- Energy Efficient Ethernet (EEE) support with Low-Power Idle (LPI) mode for 100BASE-TX and Transmit Amplitude Reduction with 10BASE-TE option
- Wake-on-LAN (WoL) Support with Either Magic Packet, Link Status Change, or Robust Custom-Packet Detection
Important note for the external magnetic connectionEdit
The Ethernet peripheral requires an external insulator magnetic on the carrier board.
The two transformer center tap pins on the PHY side should not be connected to any power supply source on the board; rather, the center tap pins should be separated from one another and connected through separate 0.1 µF common-mode capacitors to ground. Separation is required because the common-mode voltage could be different between the four differential pairs, depending on the connected speed mode.
See section 11 (Magnetic connection and selection) on KSZ8091RN datasheet for more details.
Pin mappingEdit
The Pin mapping is described in the Pinout table section