| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
| History | |||
|---|---|---|---|
| Version | Issue Date | Notes | |
| 1.0.0 | Dec 2020 | First Release | |
Contents
UARTs interfaceEdit
DescriptionEdit
The UART interfaces are available on the Evaluation Kit at the connectors J9 and J10.
J9 and J10 are 3 pin terminal blocks 5.0mm pitch respectively for USART3 and UART8. Can be independently used as RS232 or RS485 based on Part Number composition.
SignalsEdit
The following table describes the interface signals:
J9Edit
| Pin# | SOM Pin# | RS232 | RS485 | Pin Notes |
|---|---|---|---|---|
| 1 | J18.89 | USART3_TX | RS485_A | |
| 2 | J18.91 | USART3_RX | RS485_B | |
| 3 | - | Ground | Ground |
J10Edit
| Pin# | SOM Pin# | RS232 | RS485 | Pin Notes |
|---|---|---|---|---|
| 1 | J18.191 | UART8_TX | RS485_A | |
| 2 | J18.193 | UART8_RX | RS485_B | |
| 3 | - | Ground | Ground |
Device mappingEdit
|
Section not completed yet |
USART3 is mapped to /dev/ttyxxx device in Linux.
UART8 is mapped to /dev/ttyxxx device in Linux.
Device usageEdit
Fix the signal cables to the terminal with a small flat screwdriver.