Customizing the splash screen (Axel)

Info Box Applies to Axel Ultra Applies to Axel Lite Applies to AXEL ESATTA

Contents

IntroductionEdit

Version	Date	XELK version	Hardware Part Nr	Notes
2.3.1	June 2017	XELK 2.3.1	XELK 2.0.0
3.0.1	Nov 2017	XELK 3.0.1	XELK 3.0.1

Starting from version 2013.04-xelk-2.2.0, U-Boot for Axel SOMs provides support for a customizable splash screen. The following sections describe how to use this feature.

ResourcesEdit

For further details on splash screen support in U-Boot, please refer to:

• http://www.denx.de/wiki/DULG/UBootSplashScreen
• http://www.denx.de/wiki/DULG/UbootBitmapSupport.

Customizing the splash screenEdit

The following U-Boot environment variables are required:

• splashimage: RAM address where the BMP image is loaded. Please note that it must be a 32-bit aligned address with a 0x2 offset (eg: 0x20000002)
• loadsplash: comand for loading the BMP image from the storage device (e.g flash memory) to RAM. This command is automatically run by U-Boot at startup
• splashpos: image position (eg: splashpos=m,m, for centering the image)

Splash image in NOR SPI flashEdit

U-Boot variablesEdit

loadsplash=run spi_loadsplash
spi_loadsplash=sf probe; sf read ${splashimage} 0x800000 ${splashsize}
splashfile=splash_image.bmp
splashimage=0x20000002
splashpos=m,m
splashsize=0x400000
loadsplashfile=tftpboot ${loadaddr} axel/${splashfile}
spi_updatesplash=sf probe; sf erase 0x800000 +${filesize}; sf write ${loadaddr} 0x800000 ${filesize}

CommandsEdit

The following commands are used to store in NOR SPI flash a BMP image loaded via tftp:

run loadsplashfile
run spi_updatesplash

Splash image in NAND flashEdit

U-Boot variablesEdit

mtdparts=mtdparts=gpmi-nand:8M(nand-uboot),1M(nand-env1),1M(nand-env2),1M(nand-fdt),1M(nand-spare),8M(nand-kernel),4M(nand-splash),-(nand-ubi)
loadsplash=run nand_loadsplash
nand_loadsplash=nand read ${splashimage} nand-splash
splashfile=splash_image.bmp
splashimage=0x20000002
splashpos=m,m
splashsize=0x400000
loadsplashfile=tftpboot ${loadaddr} axel/${splashfile}
nand_updatesplash=nand erase.part nand-splash; nand write ${loadaddr} nand-splash ${filesize}

Please note that the NAND mtd partition for the splash image (nand-splash) is defined using the mtdparts parameter, and then referenced by the nand {erase,read,write} commands.

CommandsEdit

The following commands are used to store in NAND flash a BMP image loaded via tftp:

run loadsplashfile
run nand_updatesplash