Bureaucrats, dave_user, Administrators
4,650
edits
Changes
→Notes about physical interfaces
===Ethernet===
Please refer to [[#Adding packages|this section]].
===Bluetooth and WiFi===The root file system contains the same calibration file indicated [[XUELK-AN-001:_Using_WiFi-Bluetooth_combo_plugin_with_SBC_Lynx#Calibration|here]].====Bluetooth====The following script can be run to enable the Bluetooth controller:<pre>root@arm:~# ./test/dwm_bt_init.shFound a Texas Instruments' chip!Firmware file : /lib/firmware/ti-connectivity/TIInit_7.6.15.btsLoaded BTS script version 1texas: changing baud rate to 3000000, flow control to 1Device setup completeDevices: hci0 88:33:14:5E:30:60</pre>Once the <code>hci</code> interface is enabled, <code>hcitool</code> or other tools can be used to access it:<pre>root@arm:~# hcitool scanScanning ... yy:yy:yy:yy:yy:yy device1 zz:zz:zz:zz:zz:zz device2</pre>====WiFi (client mode)====
The procedure here described can be used to connect to an Access Point, using the WPA2/PSK security protocol.
