===Bootstrap settings===
When Naon module is plugged onto Please refer to [[bootstrap settings (NaonEVB-Lite carrier board, BTMODE[4:0)] bootstrap pins are changed as follows:* BTMODE[4:0]: 00010.Thus boot sequence is:# UART# SPI# NAND# NANDI2C. This configuration can be changed by acting on S5 dip switch on bottom side of the board. Swithes allow to configure each BTMODE signal independently as summarized by following table. Settings denoted as RFU - that stands for "Reserved for future use" - '''must not be selected'''. {| class="wikitable" !NELK version|-|Switch position|BTMODE|-|S5.1 off|default|-|S5.1 on|BTMODE0=1|-|S5.2 off|default|-|S5.2 on|RFU|-|S5.3 off|default|-|S5.3 on|RFU|-|S5.4 off|default|-|S5.4 on|BTMODE1=0|-|S5.5 off|default|-|S5.5 on|BTMODE2=1|-|S5.6 off|default|-|S5.6 on|RFU|-|S5.7 off|default|-|S5.7 on|BTMODE3=1|-|S5.8 off|default|-|S5.8 on|RFU|-|S5.9 off|default|-|S5.9 on|BTMODE4=1|-|S5.10 off|default|-|S5.10 on|RFU|-|S5.11 off|default|-|S5.11 on|RFU|-|S5.12 off|default|-|S5.12 on|RFU|}
