3,260
edits
Changes
m
no edit summary
===Quick start===
# connect the serial cable, provided with the board, to J25
# connect this cable to PC COM port through a NULL-modem cable (not provided)
# start your favourite terminal software on PC; communication parameters are:
#* baud rate: 115200 Bps
#* data bits: 8
#* stop bits: 1
#* parity: none
# (optional) to connect the system to Ethernet LAN, please plug cable on connector J3
# connect a 12Vcc power supply to JP1
Once power has been applied, U-Boot bootloader will be executed and the following messages will be printed on serial console (please note that messages may vary due different U-Boot releases)
<pre class="terminal-output">
CCCCCCCC
U-Boot 2010.06-dirty (Apr 27 2012 - 18:58:24) [nelk-0.9.0-min]
TI8148-GP rev 2.1
ARM clk: 600MHz
DDR clk: 333MHz
DRAM: 512 MiB
Using default environment
Hit any key to stop autoboot: 0
8192 KiB AT45DB642D at 0:0 is now current device
## Starting application at 0x81000000 ...
U-Boot 2010.06-dirty (Apr 30 2012 - 19:23:20) [nelk-0.9.0]
TI8148-GP rev 2.1
ARM clk: 600MHz
DDR clk: 333MHz
I2C: ready
DRAM: 512 MiB
NAND: HW ECC Hamming Code selected
1024 MiB
MMC: OMAP SD/MMC: 0
Net: Detected MACID:d4:94:a1:8e:22:19
cpsw
NAON#
</pre>
