MITO 8M SOM/MITO 8M Hardware/Electrical Thermal and Mechanical Features/Thermal management and heat dissipation

History
Issue Date	Notes
2020/10/19	First release

Thermal management

The MITO 8M SOM is designed to support the maximum available temperature range declared by the manufacturer.

The customer shall define and conduct a reasonable number of tests and verification in order to qualify the DUT capabilities to manage the heat dissipation.

Any heatsink, fan etc shall be defined case by case.

DAVE Embedded Systems' team is available for any additional information, please contact sales@dave.eu.

Heatsink suggestion

The MITO 8M SOM is designed with two holes that allow to mount a heatsink directly on the CPU IC.

Suggested part are ATS Push Pin Heat Sinks CPX0250250xx or FPX0250250xx part numbers.

See ATS website for more details [1].

Software thermal protection

In DESK-MX8-L, two software thermal protection mechanisms are implemented. Both are based on the processor's temperature sensor. It is worth remembering that maximum junction temperature (also denoted as Tj in the rest of the document) is:

• 95°C for Consumer parts
• 105°C for Industrial parts

Section not completed yet

U-Boot

At U-Boot level, automatic boot procedure is halted until Tj is smaller than (following temperatures might seem excessively low but they take into account the intrinsic poor precision of the temperature sensor to provide a reasonable safe margin):

• TBD for Consumer parts
• 95°C for Industrial parts

Linux kernel

At Linux level, a more sophisticated protection mechanism is implemented. Please refer to the following sections for more details.

The default temperature thresholds depend on the silicon grade, as follows:

• for Consumer parts
  • passive threshold: TBD
  • critical threshold: TBD
• for Industrial parts
  • passive threshold: 85°C
  • critical threshold: 95°C

Practically speaking, for DESK-MX8-L this mechanism makes use of two different thresholds, denoted as trip_point0 (also known as passive threshold) and trip_point1 (also known as critical threshold).

When Tj reaches trip_point0, Linux kernel scales down processor frequency.

If Tj reaches trip_point1, a complete shutdown is triggered:

thermal thermal_zone0: critical temperature reached(95 C),shutting down

By default, temperature thresholds are set up as follows:

• trip_point0: 85°C
• trip_point1: 95°C.

Trip point thresholds can be accessed via sysfs interface from user space. The following example shows how to read the values of the trip points:

root@mito:~# cat /sys/devices/virtual/thermal/thermal_zone0/trip_point_0_temp
85000
root@mito:~# cat /sys/devices/virtual/thermal/thermal_zone0/trip_point_1_temp
950000

This example shows how to set trip points 0 and 1 to 95°C and 100°C respectively:

echo 95000 > /sys/class/thermal/thermal_zone0/trip_point_0_temp
echo 100000 > /sys/class/thermal/thermal_zone0/trip_point_1_temp

Please note that:

• it is possible to set up trip points greater than the maximum junction temperature indicated by manufacturer datasheet;
• exceeding maximum junction temperature indicated by manufacturer datasheet may cause permanent damage.

To read current processor temperature please issue this command (reported temperature is 36.676°C in the example):

root@mito:~# cat /sys/class/thermal/thermal_zone0/temp
36676

For more details about this functionality, please refer to Documentation/thermal/sysfs-api.txt in the kernel sources.

---