This section describes how to quick start NaonEVB-Mid-based system, provided that it is programmed according to NELK configuration.
# connect the serial cable, provided with the board, to J17 # connect this cable to PC COM port through a NULL-modem cable (not provided) # start your favourite terminal software on PC; communication parameters are: #* baud rate: 115200 Bps #* data bits: 8 #* stop bits: 1 #* parity: none # (optional) to connect the system to Ethernet LAN, please plug cable on connector J11 # (optional) to connect the system to HDMI TV/LCD, please plug cable on connector J6 # connect a 12Vcc power supply to J14
Once power has been applied, U-Boot bootloader will be executed and the following messages will be printed on serial console (please note that messages may vary due different U-Boot releases)
