Bureaucrats, dave_user, Administrators
8,154
edits
Changes
no edit summary
|
|}
==== Connector part number ====
* on module: Molex 501920-3001
* on Carrier board: for example Molex 52991-0308 (dependon on stand-off chosen)
==Antenna connector==
====Electrical guidelines====
*Keep SDIO lines as short as possible.
*5V and 3.3V rails can power up in any order
*Keep WIFI_EN asserted during power-up sequence
===Mechanical information===
[[File:Dwm-layout-top.png|thumbnail|center|300px|DWM dimensions]]
* DXF: httphttps://www.dave.eu/system/files/area-riservata/dwm.dxf_.zip
===Layout===
The component view (top and bottom) is available as PDF file:
* PDF: httphttps://www.dave.eu/system/files/area-riservata/CS061412B_all_view.pdf
===3D===
* IDF (3D): httphttps://www.dave.eu/system/files/area-riservata/dwm-3D.zip
===Calibration process===
The radio interface of the DWM module is configured by several parameters. These parameters are set through a calibration process, that is described in detail [http://processors.wiki.ti.com/index.php/WL12xx_NLCP_Calibration_Process here].
The following links refer to specific use cases, where the resulting NVS file is provided along with DAVE Embedded Systems products integrating DWM module.
*[[XUELK-AN-001:_Using_WiFi-Bluetooth_combo_plugin_with_SBC_Lynx|SBC Lynx(XUELK)]]*[[XUELK-AN-002:_Running_Debian_distribution#Bluetooth_and_WiFi|SBC Lynx (Debian)]]
== References ==
