Video input/output interfaces (NaonEVB-Mid)
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
Info Box
|
Contents
Introduction[edit | edit source]
NAON provides many different video input/ouput interfaces (see also Video input ports (Naon) and Video output ports (Naon)).
NaonEVB-Mid carrier board integrates several connectors that allow to exercise these interfaces. Following sections details each of them. Please note that different video ports may have pins in common. Therefore different video ports may not work at the same time.
J19/J24 (VIN0)[edit | edit source]
These 2.54mm-pitch connectors route parallel 24-bit VIN0 port. It is available a hardware add-on implementing a DVI receiver that matches these connectors.
J25/J26 (VIN1A/VOUT1)[edit | edit source]
These 2.54mm-pitch connectors route parallel 24-bit VIN1A port and parallel 30-bit VOUT1 port. Please note that VIN1A and VOUT1 share several pins, thus these two functionalities are mutually exclusive.
J27 (ISS camera sensor interface)[edit | edit source]
This connector routes ISS camera sensor interface (16-bit). It is compatible with LI-MOD01 Camera Module Adapter Board for DM355/DM365.
J28 (ISS camera sensor interface)[edit | edit source]
This connector routes ISS camera sensor interface (16-bit). It is compatible with LI-CAM-AR0331 camera board.
J6 (HDMI VOUT1)[edit | edit source]
This connector implements HDMI port associated to VOUT1.
