{{ImportantMessage|text=This page provides information for the AxelEVB-Lite carrier board model S-EVBA1000C1R (BOM 1.0.4), provided with XELK kits version 2.1.0 and above.
For AxelEVB-Lite revision 0 manufactured before the release of XELK 2.1.0, please refer to [[AxelEVB-Lite_rev.0|this page]].
==Introduction==AxelEVB-Lite is a carrier board designed to host [[Axel Ultra SOM:Category:AxelUltra|Axel UltraAXEL ULTRA]] and [[Axel Lite SOM:Category:AxelLite|Axel LiteAXEL LITE]] (through an adapter) SoMs. It exports some specific peripherals connectors and acts as an adaptation board used in combination with [[:Category:Dacu|Dacu]] carrier board. {{ImportantMessage|text=This page provides information for the AxelEVB-Lite carrier board model S-EVBA1000C1R (BOM 1.0.4), provided with XELK kits version 2.1.0 and above. If you have a board from a previous version of the XELK kit (older than 2.1.0), please contact [mailto:support-axel@dave.eu support-axel@dave.eu].}}
==Block Diagram==
The following picture shows Axel-EVB-Lite's block diagram:
The AxelEVB-Lite carrier board can host two different SoM's, [[:Category:AxelUltra|Axel Ultra]] and [[:Category:AxelLite|Axel Lite]].
The following sections detail boot configuration options, which differ depending on the SoM.
===Axel Ultra======= uSD card ====
Dip-switch configuration:
</pre>
=== = SPI NOR SPIflash ====
Dip-switch configuration:
S9[1..2] : Off Off
</pre>
===Axel Lite===
In this case, it is required to use the [[AxelEVB-Lite-Adapter (AxelLite)|specific revision A adapter]] to plug the SoM. Regarding the boot options, please refer to [[AxelEVB-Lite-Adapter_(AxelLite)#Revision_A_2|this section]].