170
edits
Changes
no edit summary
'''Tool preparation'''
* Download the zip archive lizard-Recovery.zip and extract it in a folder
* Open the command prompt and go inside the utility folder
* Lunch the uitility with the serial port number
C:\Users\Desktop\lizard-Recovery\lizard> .\uart-recovery_V2.bat COM1
{{InfoBoxTop}}
{{AppliesToLizard}}
{{AppliesToLizardEVB-Lite}}
{{InfoBoxBottom}}
'''Board Preparation'''
* Power down the board and set the deep switch 2 1 configuration.
* Connect the serial console to the PORT2 of your board.
* Turn the board on.
'''Flashing the firmware'''
If everithing was set correctly, this message should appear on your screen
<pre>
ASIC ID Detected.
Sending 2ndFile:
Downloading file: 100.000% completed(15232/15232 bytes)
File download completed.
In attesa da 0 secondi. Premere un tasto per continuare...
Downloading file: 100.000% completed(218792/218792 bytes)
File Download completed
Open Serial Console and write this command
.
.
"=> mw.w ${buf} 0xFF 0x40000; loadb ${buf} 115200"
.
.
CLOSE Serial Console !!!!!!
</pre>
Now it is necessary to open a serial console for example Putty and insert the following command
<pre>
mw.w ${buf} 0xFF 0x40000; loadb ${buf} 115200
</pre>
Now close the command line and pres <code>Enter</code> inside the command prompt.
A new download will start.
<pre>
Downloading file: 100.000% completed(218792/218792 bytes)
File Download completed
.
.
Open Serial Console and write this command
"=> protect off 0x08000000 +40000;era 0x08000000 +40000;cp.b ${buf} 0x08000000 0x40000"
"=> res"
.
.
.
</pre>
When the download is finished, you need to reopen putty and insert this command
<pre>
protect off 0x08000000 +40000;era 0x08000000 +40000;cp.b ${buf} 0x08000000 0x40000
res
</pre>
If everithing went ok, you shuld
* Turn off the board.
* Change the sweetch position to reflect the original one.
* Turn on the board.