Open main menu

DAVE Developer's Wiki β

MITO 8M Nano SOM/MITO 8M Nano Evaluation Kit/Interfaces and Connectors/DWS

< MITO 8M Nano SOM‎ | MITO 8M Nano Evaluation Kit
Revision as of 13:47, 10 May 2022 by U0007 (talk | contribs)

History
Version Issue Date Notes
1.0.0 May 2022 First release



Contents

DWSEdit

DescriptionEdit

J24 is a 30-pins 0.50mm Pitch SlimStack™ Receptacle. This connector is dedicated to the DWS optional add-on module.

The module is built around an Telit WE866C6-P Dual Band (2.4GHz and 5GHz) 802.11 ac WiFi and Bluetooth 5 module. The module implements the necessary PHY/MAC layers to support WLAN applications in conjunction with a host processor over a SDIO interface. The module also provides a Bluetooth platform through the HCI transport layer. Both WLAN and Bluetooth share the same antenna port.

 
DWS connector

SignalsEdit

The following table describes the interface signals:

Pin# SOM Pin# Pin name Pin function Pin Notes
1, 2 - 5V
3, 4 - 3.3V
5, 6, 9, 10, 19 - DGND Ground
7 J10.69 SDIO_CMD
8 J10.71 SDIO_CLK
11 J10.61 SDIO_DAT0
13 J10.63 SDIO_DAT1
15 J10.65 SDIO_DAT2
17 J10.67 SDIO_DAT3
21 J10.47 UART4_RX Used only for BT peripheral
23 J10.55 UART4_CTS Used only for BT peripheral
24 J10.39 WIFI_CLK_REQ Reserved
25 J10.49 UART4_TX Used only for BT peripheral
26 J10.41 BT_F2 Reserved
27 J10.59 UART4_RTS Used only for BT peripheral
28 J10.43 WIFI_IRQ
29 J10.99 BT_EN
30 J10.45 WIFI_EN
12, 14, 16, 18, 20, 22 - N.C. Not connected

Device mappingEdit

The WiFi peripheral is mapped to the corresponding wlan<X> device in Linux. The network peripheral is visible under the ifconfig network configuration utility.

Device usageEdit

The peripheral is used the standard kernel interface and network protocol stack.