The [[Logical_structure_of_Bora_and_BoraX_Embedded_Linux_Kits_(<section begin=BELK/BXELK)|>== Host setup and development flow==The software development flows]] environment for BoraX requires the use of Processing Subsystem (PS) is quite complex because it is based on several tools on host side. This document collects several the resources , available in this wiki, which are related to these tools, in order to illustrate how to install and set up these toolsthem.

First, '''it is strongly recommended the reading of [[BORA_SOM/BELK-L/General/Logical_structure_of_BELK|this document]] to understand the general structure of the kit'''. For setting up the development environment, please refer to the following documents:*Please first refer to [[BORA_SOM/BELK-L/Development/Introduction_to_the_development_environment | Introduction to developing the development environment (BELK/BXELK)|this document]] to have which provides an overview of it*Then, refer to [[Build system (BORA_SOM/BELK-L/Development/BXELK)Build_system |this addressBuild system]] for operational instructions.

*[[Building UBORA_SOM/BELK-L/Development/Building_U-Boot (BELK/BXELK)|This page]] for detailed instruction on U-Boot building*[[Building Linux kernel (BORA_SOM/BELK-L/Development/BXELK)Building_Linux_kernel|This page]] for detailed instruction on Linux kernel building*[[Building_the_software_components_via_Yocto_(BORA_SOM/BELK-L/Development/BXELK)Advanced_use_of_Yocto_build_system|This link]] shows hot to use Yocto build system to build the entoire entire BSP, including U-Boot bootloader, Linux kernel and root file system.

About Programmable Logic (PL), please refer to [[Creating_and_building_example_Vivado_project_(BORA_SOM/BELK-L/BXELK)Development/Creating_and_building_a_Vivado_example|this page]] that illustrates a simple reference design for BoraEVB [[BORA_SOM/BORA_Evaluation_Kit | BORA Evaluation kit]] and BoraXEVB[[BORA_Xpress_SOM/BORA_Xpress_Evaluation_Kit | BORA Xpress Evaluation kit]].<section end=BELK/>