DivaEVB-Lite

Info Box Applies to Diva

Introduction

DivaEVB-Lite is a carrier board designed to host Diva system-on-module. It can also act as an adaptation board used in combination with Dacu carrier board. Therefore two different versions exist that are a little bit different.

DivaEVB-Lite Standalone version

The following picture shows Diva-EVB-Lite's block diagram when configured as standalone carrier board:

DivaEVB-Lite for Dacu

When used in combination with Dacu, please note the points listed below:

• the following parts are not installed because their respective functionality is already implemented on DACU board
  • USBOTG port
  • RS232 UART port
  • PSU.
• some wired connections are necessary; these are detailed in the Schematics section.
• on J18 connector, a jumper must be placed on positions 1-2 and 3-4

Please see also Dacu for the Diva SOM.

Schematics

Please note that Orcad CIS is required to get all the information about BOM variants included in .dsn files. PDF files show statically the BOM variants used to manufacture different versions of the board (if any). Components that are not populated are denoted as "Do Not Stuff".

• ORCAD: http://www.dave.eu/system/files/area-riservata/divaevb-lite-1.0.3-DIVELK-dsn.zip
• PDF
  • DivaEVB-Lite for DACU: http://www.dave.eu/system/files/area-riservata/divaevb-lite-1.0.3-S.EVBDL1000C.1.0.3.pdf
  • DivaEVB-Lite standalone: http://www.dave.eu/system/files/area-riservata/divaevb-lite-1.0.3-S.EVBDL0000C.1.0.0.pdf

BOM

• DivaEVB-Lite for DACU: http://www.dave.eu/system/files/area-riservata/divaevb-lite_BOM_S-EVBDL1000C-1.0.3.csv_.zip

Layout

• http://www.dave.eu/system/files/area-riservata/divaevb-lite-CS143112A_component_view.pdf

Mechanical

• DXF: http://www.dave.eu/system/files/area-riservata/divaevb-lite_2D_CS143112A.zip
• IDF (3D): http://www.dave.eu/system/files/area-riservata/divaevb-lite_3D_CS143112A.zip