3,260
edits
Changes
Dacu
,→"Full control" mode
==== "Full control" mode ====
# connect the serial cable, provided with the board, to J3 pin-strip connector
# connect this cable to PC COM port through a NULL-modem cable (not provided)
# start your favourite terminal software on PC; communication parameters are:
#* stop bits: 1
#* parity: none
# (optional) to connect the system to Ethernet LAN(RJ45 connector, please plug cable on connector J6)# connect a 12Vcc power supply to Once to the power has been applied, U-Boot bootloader will be executed and the following messages will be printed on serial console jack (please note that messages may vary due different U-Boot releasesJP2)
Once power has been applied, U-Boot bootloader will be executed and the following messages will be printed on serial console:
==== "Normal" mode ====