Bureaucrats, dave_user, Administrators
4,650
edits
Changes
→Ethernet connector (J16)
|4||-||DGND||Ground||-||-||-
|}
J42 connector is compatible with [http://www.ftdichip.com/Support/Documents/DataSheets/Cables/DS_TTL-232RG_CABLES.pdf FTDI TTL-232RG-VIP-WE cable]. To connect it, please use this wiring:
*J42.1: yellow wire
*J42.2: orange wire
*J42.3: red wire
*J42.4: black wire
==Ethernet connector (J16)==
J16 is a standard RJ45 10/100BaseT Ethernet connector - incorporating magnetics - connected to the Ethernet controller and PHY.
J16 integrates a green status LED providing connection information:
*LED on: link established
*LED blinking: activity.
[5] '''To be used for voltage reference only'''.
===Handling bootstrap signals===
MEZZANINE_GP0, MEZZANINE_GP1 and MEZZANINE_GP2 are connected to LCD_DATA19, LCD_DATA22 and LCD_DATA23 respectively. As such, they act as bootstrap configuration signals as well. They can be used by application software freely and the they can be connected to user's application circuitry. However, '''any electrical interference during the processor reset cycle must be avoided'''.
There are different solutions to comply with this requirement. The following image shows a concept solution for this problem.
[2] This signal can be routed here instead of connector J48. Please refer to the [mailto:sales@dave.eu Sale Deparment] for more details.
[3] See LCD_DATAx signals act as bootstrap configuration pins as well. They can be used by application software freely and they can be connected to user's application circuitry. However, '''any electrical interference during the processor reset cycle must be avoided'''. Please see [[#Handling bootstrap signals|Handling bootstrap signals]] sectionfor more details.
==DWM WiFi/Bluetooth module connector (J46)==
