Bootstrap settings (NaonEVB-Lite)
Revision as of 09:13, 18 May 2012 by DevWikiAdmin (talk | contribs) (Created page with "{{InfoBoxTop}} {{Applies To NaonEVB-Lite}} {{InfoBoxBottom}} When Naon module is plugged onto NaonEVB-Lite carrier board, BTMODE[4:0] bootstrap pins are changed as follows: * ...")
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
Info Box
|
When Naon module is plugged onto NaonEVB-Lite carrier board, BTMODE[4:0] bootstrap pins are changed as follows:
- BTMODE[4:0]: 00010.
Thus boot sequence is:
- UART
- SPI
- NAND
- NANDI2C.
This configuration can be changed by acting on S5 dip switch on bottom side of the board. Swithes allow to configure each BTMODE signal independently as summarized by following table. Settings denoted as RFU - that stands for "Reserved for future use" - must not be selected.
| Switch position | BTMODE |
| S5.1 off | default |
| S5.1 on | BTMODE0=1 |
| S5.2 off | default |
| S5.2 on | RFU |
| S5.3 off | default |
| S5.3 on | RFU |
| S5.4 off | default |
| S5.4 on | BTMODE1=0 |
| S5.5 off | default |
| S5.5 on | BTMODE2=1 |
| S5.6 off | default |
| S5.6 on | RFU |
| S5.7 off | default |
| S5.7 on | BTMODE3=1 |
| S5.8 off | default |
| S5.8 on | RFU |
| S5.9 off | default |
| S5.9 on | BTMODE4=1 |
| S5.10 off | default |
| S5.10 on | RFU |
| S5.11 off | default |
| S5.11 on | RFU |
| S5.12 off | default |
| S5.12 on | RFU |
