Changes

Jump to: navigation, search

AxelEVB-Lite

563 bytes added, 10:55, 3 December 2019
Axel Lite
{{ImportantMessage|text=This page provides information for the AxelEVB-Lite carrier board model S-EVBA1000C1R (BOM 1.0.4), provided with XELK kits version 2.1.0 and above.
 
For AxelEVB-Lite revision 0 manufactured before the release of XELK 2.1.0, please refer to [[AxelEVB-Lite_rev.0|this page]].
}}
 
 
{{InfoBoxTop}}
{{AppliesToAxel}}
{{AppliesToAxelLite}}
{{AppliesToAxelEsatta}}
{{InfoBoxBottom}}
[[File:Axelevb-lite-01.png|500px|frameless|border]]==Introduction==
==Introduction==AxelEVB-Lite is a carrier board designed to host [[File:Axel Ultra SOM-evb-lite-revA 02.jpg|Axel Ultra]] and [[Axel Lite SOM500px|Axel Lite]] (through an adapter) SoMs. It exports some specific peripherals connectors and acts as an adaptation board used in combination with [[:Category:Dacuframeless|Dacuborder]] carrier board.
{{ImportantMessage|text=This page provides information for the AxelEVB-Lite is a carrier board model S-EVBA1000C1R designed to host [[:Category:AxelUltra|AXEL ULTRA]] and [[:Category:AxelLite|AXEL LITE]] (BOM 1.0.4through an adapter), provided with XELK kits version 2SoMs.1.0 It exports some specific peripherals connectors and above. If you have a acts as an adaptation board from a previous version of the XELK kit (older than 2.1.0), please contact used in combination with [[mailto:support-axel@dave.eu support-axel@dave.euCategory:Dacu|Dacu]]carrier board.}}
==Block Diagram==
The following picture shows Axel-EVB-Lite's block diagram:
[[File:Axelevb-lite-block diagram.png|700px|frameless|border|centre]]
== Features ==
=== MIPI camera connector - J53 ===
J16 J53 is a 33-pin 0.50mm pitch ZIF connector
The following table reports the connector's pinout:
!Notes
|-
|1 || - || - || Connetted Connected to pin 3
|-
|2 || DGND|| Ground|| -
|-
|3 || - || - || Connetted Connected to pin 1
|-
|4, 6, 8, 10,<br>12, 14, 16 || NVCC_CSI_EXT|| - || -
!Notes
|-
|1 || - || - || Connetted Connected to pin 3
|-
|2 || DGND|| Ground|| -
|-
|3 || - || - || Connetted Connected to pin 1
|-
|4, 6, 8, 10,<br>12, 14, 16 || NVCC_EIM_EXT|| - || -
== Boot configurations ==
The AxelEVB-Lite carrier board can host two different SoM's, [[:Category:AxelUltra|Axel Ultra]] and [[:Category:AxelLite|Axel Lite]].
The following sections detail boot configuration options, which differ depending on the SoM. ===Axel Ultra======= uSD card ====
Dip-switch configuration:
</pre>
=== = SPI NOR SPIflash ====
Dip-switch configuration:
S9[1..2] : Off Off
</pre>
===Axel Lite===
In this case, it is required to use the [[AxelEVB-Lite-Adapter (AxelLite)|specific revision A adapter]] to plug the SoM. Regarding the boot options, please refer to [[AxelEVB-Lite-Adapter_(AxelLite)#Revision_A_2|this section]].
== Technical documents ==
===Schematics===* ORCAD: http://mirror.dave.eu/systemaxel/fileshw/areaAxelEVB/rev-riservataA/axelevb-lite_S-EVBA1000C1R_1.0.48.pdfdsn_.zip* PDF: http://mirror.dave.eu/systemaxel/hw/filesAxelEVB/arearev-riservataA/axelevb-lite-Slite_S-EVBA1000C1R_1.0.48.dsn_.zippdf
===BOM===* AxelEVB-Lite: http://mirror.dave.eu/systemaxel/fileshw/AxelEVB/arearev-riservataA/axelevb-lite_SAXELEVB-EVBA1000C1R_1LITE_S.0EVBA1000C1R.4-BOM1.csv_0.8.zip
===Layout===* http://mirror.dave.eu/systemaxel/hw/filesAxelEVB/arearev-riservataA/axelevb-lite_S-EVBA1000C1R_CS151613A_AssemView.pdf
===Mechanical===* DXF: http://mirror.dave.eu/systemaxel/hw/filesAxelEVB/arearev-riservataA/axelevb-lite-S-EVBA1000C1R_CS151613A-2D.dxf_.zip* IDF (3D): http://mirror.dave.eu/systemhw/axel/filesAxelEVB/arearev-riservataA/axelevb-lite-S-EVBA1000C1R_CS151613A-3D.idf_.zip
4,650
edits

Navigation menu