[2] Carrier Board 0x00000013 (SBC Lynx CS214515B) uses same dtb file as 0x0000000C [3] Carrier Board 0x0000002D/2E/2F/30 have its own device tree file for different peripherals mapping
====Downloadable binary images====
A summary of images with a brief description can be found into the table below:
{{ImportantMessage|text=In For [[AXEL_ULite_and_SBC_Lynx_Embedded_Linux_Kit_(XUELK)#XUELK_software_components|XUELK releases]] 1.1.3 and older, in order to boot Linux from SD card files, '''the binary files must be renamed''' as follows:
* Update Yocto BSP to latest Krogoth to fix WPA2 key replay security bug (for more details see [http://git.yoctoproject.org/cgit/cgit.cgi/poky/commit/?h=krogoth&id=54e3f82bd77203c3d578e26c86506e6ef5c27000])
===== Notes 2.0.1 =====
Major update on XUELK 1.2.0:
* BSP update to NXP 4.1.15-2.0.0_ga
* Minor fixes for Wifi and BT
===== Known issues and limitations =====
The following table reports the known limitations of this XUELK release:
{| class="wikitable"
|-
!Limitations
!Description
|-
|USB OTG Current Limit
|USB OTG current limit is set at 75mA in Host mode
|-
|Low Power Idle not supported
|Low Power Idle is not supported in this release
|}
==== XUELK 1.2.0 ====
===== Notes =====
Minor update on XUELK 1.1.3:
* add CPU temperature for thermal thresholds settings
* add rf kill support for Bluetooth on device tree
* add [[ConfigID and UniqueID|ConfigID]] support for different hardware configurations: SOM_ConfigID and CB_ConfigID
* minor fixes and enhancement
===== Known issues and limitations =====
The following table reports the known limitations of this XUELK release:
{| class="wikitable"
|-
!Issue
!Description
|-
|USB OTG Current Limit
|USB OTG current limit is set at 75mA in Host mode
|-
|Low Power Idle not supported
|Low Power Idle is not supported in this release
|-
|Bridged network configuration without DHCP server
This section describes how to quick start SBC Lynx board delivered along with XUELK kit(see also the following image):
*connect a TTL/USB serial cable to J42 connector; J42 pinout is:
** 1: TX data
* change dir to the ext3 SD card partition
* delete previous files and extract new files from tarball archive as described [[AXEL_ULite_and_SBC_Lynx_Embedded_Linux_Kit_(XUELK)#Update_rfs_on_target|here]]
===Developing the software for the target===
Please refer to [[Developing the software for the target (XUELK)|this page]].