Bureaucrats, dave_user, Administrators
4,650
edits
Changes
→Quick start guide
==Quick start guide==
This chapter describes how to quickly start working with the XUELK kit. The following paragraphs will guide you through the setup and installation procedures.
===Unboxing===
TBD
===Hardware setup===
This section describes how to quick start an SBC Lynx board.
*connect a TTL/USB serial cable to J42 connector; J42 pinout is:
** 1: TX data
** 2: RX data
** 3: 3.3V
** 4: GND
*on host side start your favorite terminal; communication parameters are 11520-8-N-1
*connect the system to Ethernet LAN by plugging cable into connector J16
*connect 12V power supply to J35 connector; J35 pinout is:
**1: GND
**2: VIN.
==Related Documents ==
TBD