!colspan="4" style="width:100%; text-align:left"; border-bottom:solid 2px #ededed"|History

!style="border-left:solid 2px #73B2C7; border-right:solid 2px #73B2C7;border-top:solid 2px #73B2C7; border-bottom:solid 2px #73B2C7; background-color:#73B2C7; padding:5px; color:white"|Version!style="border-left:solid 2px #73B2C7; border-right:solid 2px #73B2C7;border-top:solid 2px #73B2C7; border-bottom:solid 2px #73B2C7; background-color:#73B2C7; padding:5px; color:white"|Issue Date!style="border-left:solid 2px #73B2C7; border-right:solid 2px #73B2C7;border-top:solid 2px #73B2C7; border-bottom:solid 2px #73B2C7; background-color:#73B2C7; padding:5px; color:white"|Notes

|style="border-left:solid 2px #73B2C7; border-right:solid 2px #73B2C7;border-top:solid 2px #73B2C7; border-bottom:solid 2px #73B2C7; background-color:#edf8fb; padding:5px; color:#000000"|X.Y.Z2020/10/19|style="border-left:solid 2px #73B2C7; border-right:solid 2px #73B2C7;border-top:solid 2px #73B2C7; border-bottom:solid 2px #73B2C7; background-color:#edf8fb; padding:5px; color:#000000"|Month Year|style="border-left:solid 2px #73B2C7; border-right:solid 2px #73B2C7;border-top:solid 2px #73B2C7; border-bottom:solid 2px #73B2C7; background-color:#edf8fb; padding:5px; color:#000000"|TBDFirst release

=== Description ===The 10/100/1000-Mbit/s Ethernet interface available on MITO 8M is based on iMX8M SoC.  The SOC is directly interfaced with an ETH PHY chip (MICROCHIP KSZ9031RNX) that has the following features: * Auto-Negotiation to Automatically Select the Highest Link-Up Speed (10/100/1000 Mbps) and Duplex (Half/Full) * On-Chip Termination Resistors for the Differential Pairs * Energy Detect Power-Down Mode for Reduced Power Consumption When the Cable is Not Attached

=== Important note for the external magnetic connection ===The Ethernet interface available peripheral requires an external insulator magnetic on MITO 8m is based on xxxxx ''TBD:SOC name'' SoCthe carrier board.

The Ethernet port supports four transformer center tap pins on the following standards PHY side should not be connected to any power supply source on the board; rather, the center tap pins should be separated from one another and features:connected through separate 0.1 µF common-mode capacitors to ground. Separation is required because the common-mode voltage could be different between the four differential pairs, depending on the connected speed mode.

* High-Definition Multimedia Interface Specification, Version 1.4a * Support See KSZ9031RNX datasheet for up to 1080p at 60Hz HDTV display resolutions and up to QXGA graphic display resolutionsmore details. * Support for 4k x 2k and 3D video formats * Support for up to 16-bit Deep Color modes

The Pin mapping is described in the [[MITO 8m 8M SOM/MITO 8m 8M Hardware/Pinout_Table | Pinout table section]]