Bureaucrats, dave_user, Administrators
4,650
edits
Changes
→Carrier board mating SO-DIMM connector - J1 pinout
| 176||NC/Monitoring
VDIG2
|||||||SO||||By default, this pin must not be connected. Optionally, it can route power voltages generated by Diva PSU. This option is meant to allow monitoring of such voltages by carrier board circuitry. It is not meant to power carrier board devices. As these options requires custom manufacturing BOMs, please contact the [mailto:sales@dave.eu Sales Department] for more information.
|-
| 177||AM335X_GMII1_TXCLK||CPU.[GMII1_TXCLK/UART2_RXD/RGMII1_TCLK/MMC0_DAT7/MMC1_DAT0/UART1_DCDN/MCASP0_ACLKX/GPIO3_9]||K18||VAUX2||IO||||
| 178||NC/Monitoring
DDR_VDDS
|||||||SO||||By default, this pin must not be connected. Optionally, it can route power voltages generated by Diva PSU. This option is meant to allow monitoring of such voltages by carrier board circuitry. It is not meant to power carrier board devices. As these options requires custom manufacturing BOMs, please contact the [mailto:sales@dave.eu Sales Department] for more information.
|-
| 179||PMIC_CLK32OUT||PMIC.CLK32KOUT||PMIC.38||VAUX33
|-
| 180||OUT_VAUX33||PMIC.VAUX33||PMIC.4||VAUX33
|SOO||||This signal can be used to synchronize powering on/off of carrier board circuitry that interfaces CPU I/O directly. Please refer to section [[Hardware_Manual_(Diva)#Power_Supply_Unit_.28PSU.29_and_recommended_power-up_sequence | PSU and recommended power up sequence]].
|-
| 181||DGND||||||||G
| 182||NC/Monitoring
VMMC
|||||||SO||||By default, this pin must not be connected. Optionally, it can route power voltages generated by Diva PSU. This option is meant to allow monitoring of such voltages by carrier board circuitry. It is not meant to power carrier board devices. As these options requires custom manufacturing BOMs, please contact the [mailto:sales@dave.eu Sales Department] for more information.
|-
| 183||PMIC_PWR_EN||CPU.PMIC_PWR_EN, PMIC.PWRHOLD||CPU.C6, PMIC.1||VRTC||O||||
| 184||NC/Monitoring
3.3V
|||||||SO||||By default, this pin must not be connected. Optionally, it can route power voltages generated by Diva PSU. This option is meant to allow monitoring of such voltages by carrier board circuitry. It is not meant to power carrier board devices. As these options requires custom manufacturing BOMs, please contact the [mailto:sales@dave.eu Sales Department] for more information.
|-
| 185||PMIC_INT1||PMIC.INT1||PMIC.45||VAUX33
