Reset scheme (Maya)
| HOME | SOMs | SBCs | ToloMEO Embedded Assistant |  GET A QUOTE
|
 ONLINE HELPDESK
|
| Roadmap | IoT Services | ML/AI services | Embedded Design Services |
Info Box
|
Contents
Accessible reset signalsEdit
Six different reset signals are provided by Maya SOM. Following sections describe in more detail each one.
Please also refer to the following image showing a simplified diagram of reset signals orgnaization.
PMIC_RESETEdit
This pin is connected to HDRST signal (cold reset) of PMIC TPS659113. When high, this signals keeps PMIC in off mode and resets TPS659113 to default settings. MRST has a weak internal pulldown.
PORSTnEdit
PORSTn is a bidirectional open-drain signal. It is connected to:
- PORn input (Power-on Reset) of DM8148 processor
- NRESPWRON2 output of PMIC.
Internal pullup is 10kOhm.
RSTOUTnEdit
This ouput signal is asserted by DM8148 processor until it gets out of reset. It is usually used to reset external memories and peripherals connetected to processor. It is connected to:
- RSTOUT_WD_OUTn pad of DM8148 processor
- 2k2 pull down resistor.
In case it is used to reset devices on carrier board:
- its driving capability has to be taken into account
- internal pull-down is required to keep this signal low while it is 3-stated by processor (please see DM8148 datasheet for more details). In case this signal is connected to devices that integrates internal pull-up, this could lead to a partitor resistor. In turn this might cause undesired voltage level on this line. System designer has to take care of this to prevent uncorrect reset sequence.
CPU_RESETnEdit
This input signal acts as External Warm Reset. It is connected to processor's RESETn pad. Internal pullup is 2.2kOhm.
JTAG_TRSTnEdit
This input signal acts as Emulation Warm Reset. It is connected to processor's TRSTn pad. Internal pulldown is 4.7kOhm
MRSTnEdit
This signal is connected to volage supervisor's manual-reset input. It is typically used to connect a push button.
When pulled low, it forces a reset at supervisor level that, in turn, triggers a power-on reset sequence.
Voltage monitorEdit
Voltage monitoring of 3.3V rail is performed by is Texas Instruments TPS3106. Reset threshold is set to 3.15V.